2008 Ford Taurus Anti Theft System Reset
2008 ford taurus anti theft system reset. Immediately afterward press the unlock button. Reset button below driver side dash. Hop in the vehicle.
The battery died and I had it replaced but now the anti-theft system needs to be reset. All you need is the key to the vehicle for this process. Reconnect the wires to the battery.
Is there a sequence of turning the key in the ignition to reset it or do I have to take it to a dealer. How do you turn off anti-theft on a 2008 Ford Taurus. How do you re-set the anti-theft device.
If it is not lit up anymore turn the key back to off and leave it for a couple of minutes. Roll the window down. This means the system is armed and working properly.
Next put Your key in the vehicles ignition and put it in the on position without the engine running. Wait for a couple of minutes to make sure that the system reset is finished. Try disconnecting your battery cables then wait about 10 minutes.
To reset the anti-theft system on your 2008 ford taurus you should first press the panic button on your remote. Follow these steps to reset the anti-theft system fully. Next turn the ignition to the 3 or run position this will reset the alarm.
This gives the system time to reset or you wont be able to start your car. When replacing the Powertrain Control Module PCM on a PATS-equipped vehicle a parameter reset or relearn procedure must be performed after the PCM is installed.
Literally would have had to shell out 500 for a replacement tow labor and uber rides.
Immediately afterward press the unlock button. Then put the key back in and try to start the car. Reconnect the wires to the battery. All You need to do is press the lock button on the key fob followed by the unlock button on the fob. When the alarm resets it chirps two times and the LED light begins blinking. Using the wrong type of key or attempting to start the engine without a properly coded key activates the system. This means the system is armed and working properly. Passive Anti-Theft Systems PATS also called Ford Securilock is a vehicle security feature introduced on 1996 and later Ford vehicles. 3 To reset the vehicles alarm put the PATS programmed key in the ignition and turn the key to the on position.
If this doesnt work and the THEFT light is still flashing you can disconnect the Positive battery cable for a short while and reset the computer. This gives the system time to reset or you wont be able to start your car. Immediately afterward press the unlock button. Press the override button. Roll the window down. Wait for a couple of minutes to make sure that the system reset is finished. By rolling the window down youre making sure you still have access to the car in case the car locks you out.
Posting Komentar untuk "2008 Ford Taurus Anti Theft System Reset"